A finger plate is the piece of door furniture most people don’t think about until they see a door without one, and notice the grubby mark where everyone’s hand goes.
What they’re for
A finger plate is a long plate fixed to the face of the door above the handle, where hands push. It takes the wear and the marks instead of the paintwork.
That’s the practical job. The other job is decorative: on a tall painted door, a pair of brass plates breaks up the expanse and gives the door some furniture.
Victorian and Georgian patterns
The two names describe different design languages rather than strict dates.
Georgian plates are plainer, with restrained edges and clean proportions. They suit the formality of Georgian joinery and look right in a hallway where everything else is understated.
Victorian plates carry more decoration, often with shaped ends or a moulded border. They suit the richer detailing of Victorian interiors, where plainness would look underdressed.
Both come at 300mm, which is the length that suits most standard internal door heights.
Where they go
- Principal rooms and hallways, where doors are pushed constantly
- Doors with no handle on the push side, where the plate is the only thing between hands and paint
- Kitchen and utility doors, for the obvious practical reason
- Both faces of a door that swings both ways
The usual position is centred on the stile, just above the handle height, so it catches the natural push point.
Finish and consistency
Finger plates are a visible piece of a set, so they should match the knobs, escutcheons and any other hardware on that door. Mixing a polished plate with an aged knob is the sort of thing that nags once you’ve noticed it.
Our guides to choosing a hardware finish and brass door furniture cover putting a consistent set together.
Fitting
Most plates fix with small screws at top and bottom. Two things to get right:
- Alignment. Measure from the door edge rather than the architrave, and check both plates on a pair of doors line up with each other.
- Screws. Use screws matching the finish. Bright steel screws in a brass plate will annoy you every time.
If you’re restoring original doors, our guide to restoring original door furniture covers dealing with old fixing holes.
Browse the range
See our finger plates alongside the rest of our door hardware, including door knobs and escutcheons.
Frequently asked questions
Just above handle height, where hands naturally push. Centring it on the stile and working to the eye usually gives the best result.
Only on the push side, unless the door swings both ways. Many people fit both faces for symmetry on principal doors.
They’ll cover the area they sit on. If the door is being repainted anyway, fitting plates afterwards stops the problem returning.

