Most hardware that gets returned wasn’t faulty. It was the wrong size, the wrong handing, or it didn’t suit the door it was bought for. Ten minutes with a tape measure prevents nearly all of it.
Here’s what to check before you order.
Door thickness
Everything that fixes through the door depends on it: knob spindles, letter plate bolts, knocker fixings and escutcheon screws. Measure at the position where the hardware will sit rather than at the edge, because panelled doors vary.
Older doors are often thicker than modern ones, and a spindle sized for a standard door will be too short.
Door knobs and handles
For door knobs, check:
- Knob diameter, which affects both grip and how it looks on the door
- Rose or backplate size, and whether it suits the stile width
- Spindle length, based on door thickness and the lock you’re using
- Projection, the distance the knob stands off the face, which matters where the door opens against a wall or architrave
On narrow stiles, a large rose can overhang the panel moulding. Measure the flat part of the stile before choosing.
Our guides to choosing the right brass door knobs and brass door handles cover style as well as size.
Locks and handing
If you’re fitting a rim lock, it’s handed. Stand on the side the lock will be fitted with the door opening towards you, and note which side the hinges are on. Our rim lock guide explains it in more detail.
For mortise locks, check the backset, which is the distance from the edge of the door to the centre of the spindle, since it decides where the knob sits.
Letter plates
Measure the aperture in the door, the fixing centres and the door thickness. Our letter plate sizing guide walks through it.
Escutcheons
Check the keyhole size and shape, and whether the keyhole passes through the door, in which case you need one on each face. See our guide to escutcheons and keyhole covers.
Cabinet and drawer hardware
This is where mistakes are most common, because the tolerances are smaller:
- Centres for drawer pulls, the distance between fixing holes. Match the existing holes exactly unless you’re prepared to fill and redrill
- Projection and clearance, so the pull clears the adjacent door or worktop
- Screw length for the thickness of the drawer front, including any applied panel
- Knob diameter for cupboard knobs, in proportion to the door size
Our guide to cabinet hardware covers choosing between knobs and pulls.
Count everything twice
Before ordering for a whole house, count the doors, and count what each one needs. A typical internal door takes a pair of knobs, a spindle, and often a pair of escutcheons. Rim lock doors need the lock too. It’s easy to be two sets short.
Consistency across the house
Buy the whole set at once where you can. Solid brass from the same batch ages consistently, and matching a finish later is harder than it sounds. See choosing a hardware finish.
Browse the range
See our full door hardware and cabinet hardware ranges. If you’re unsure about sizing for an unusual door, get in touch and we’ll help you work it out.
Frequently asked questions
It depends on the door thickness and the lock. Measure the door where the knob will sit, then check against the spindle specification.
Measure the centres, the distance between the two fixing holes, and choose pulls with matching centres. Otherwise you’ll be filling and redrilling.
Yes. Check the flat width of the stile so the rose or backplate sits properly without overhanging the moulding.
